Stock 350 cam duration

2019-10-17 03:38

Find the flaw in the following combination: a 67 Impala running a 327 smallblock with stock heads, 8. 5: 1 compression, a 305degreeduration cam, a twobarrel carb, stock exhaust manifolds, aOct 11, 2013  Small Block Chevy 350Thumpr Cam skadill. 67 camaro big block 454 mutha thumper cam idle Flowmaster 44 Duration: 5: 30. rogerlon1 First Time On the Road in 18 Years Duration stock 350 cam duration

Chevrolet Factory Cam Specs by part number Part# Lifter typeduration at. 050 InexLift

Jan 25, 2010 I remember the duration @. 050 was and the lift was just under. 480. I ran a cam with 230 duration @. 050 and 110 LSA in an otherwise stock 350 and it wasnt at its best with a stock converter and the lack of low speed torque made drivability suffer a bit. Corvette Camshaft Specifications Written for the VetteNet Info From: Mike Doc Cobine Exhaust Duration: Exhaust Lobe Center: The 6567 L79 350 hp cam and the 68 L79 350 hp cam are shown the same in some documents and different in others. stock 350 cam duration Dec 09, 2007 What is the specs for a stock cam in a chevy 350ci? Most 70's80's smog era 350's would have had cams in the adv. duration range and around. 350 lift. The 3702 Performer cam is ground in favor of the exhaust, so if you have heads that don't flow well on the exhaust side, it should run considerably better than a stock cam

Selecting a Hydraulic Cam for your Pontiac Engine. The table below will help you select the right camshaft for your Pontiac engine. The first column contains the intended use or application category. (Stock, daily driver, streetstrip, etc) The other columns to the right, contain the intake duration stock 350 cam duration Mar 13, 2012  350 chev 292 cam, 4 bolt main, comp cam 292h, [email protected] 1. 5 stainless roller rockers, ported heads, RPM Air Gap Manifold, set base timing at 12 degree advanced A low duration camshaft works best at lower RPMs. Even though the stock cam has a duration of about 250 degrees, a mild aftermarket cam like the Engle 100 (duration 270 degrees) will still move the point of maximum torquehorsepower further up the RPM range. A cam such as the Engle 100 Dec 25, 2010 Choosing a new Camshaft for a Stock Chevy 350. Thread starter gifu; Start date Jul 2 swap a diesel, but in the meantime I want to get some more horsies out of this engine. From what I understand, the stock cam in this motor is pathetic. with a shorter duration (at least, on the exhaust). Wouldn't that lead to the same valvetrain Nov 13, 2007 Comp Cam for stock 350 yes or no Discussion in 'High Performance Modifications' started by 4wheeler, Nov 11, 2007. Page 1 of 3 1 2 3 Next The grind# on the cam is CS XE268H10 w advertised Duration and Lift. I'm not looking to get alot of hp out of the setup, but I love to here the rough lopey sound of the cam.

Rating: 4.33 / Views: 700